Instant Smile - Thermal Fitting Beads

Manufacturer: Billy Bob
SKU: BB10083

Instant Smile Billy Bob Replacement Thermal Adhesive Fitting Beads for Fake Teeth

Step 1

You will need a nice clean area, a metal spoon, and a cup or bowl.

Place teeth into very hot water until the teeth become flexible and the fitting material is soft all the way through. Tap water will not be hot enough, so the water will need to be heated to at least 130ยบ fahrenheit (think simmering or just starting to boil). It might take 2-3 minutes for the fitting material to be heated all the way through. If the fitting material is not softening, then the water you are using is not not hot enough. Once heated properly, the teeth will be flexible and the fitting material will be very soft and pliable. After the fitting material is heated all the way through, remove the teeth and fitting material from the water with a metal spoon.

Please make sure you are careful when placing the teeth in and out of the hot water. It is ok to give them a few seconds before putting them in your mouth for safety.

Step 2

Using a mirror, firmly position the Instant Smile Teeth over your existing teeth. Press them firmly against your teeth and gently pat the impression material with your thumbs behind your real teeth.

Step 3

Gently ease the teeth out of your mouth after 30 seconds and set them aside for a few minutes to allow the material to cool and harden. Do not let the fitting material cool in your mouth, make sure you remove them after 30 seconds.

If you are unhappy with the fit, you can simply reheat and remold as many times as you want.

Instant Smile Teeth are designed to work best if you have some existing tooth structure. If you do not have any teeth, you can still fit the Instant Smile Teeth but you would likely need additional fitting material so that you can form the material around your gums.

Material:  Polypropylene, Resin, BPA Free

Watch video instructions by follow the link below:

back to top